Product Care
Temperature & Humidity
General Use - Operating Temperature
The TD Pilot is best kept in dry conditions at room temperature. The recommended ranges for temperature and humidity for the device are as follows:
- Ambient temperature: 0°C to 35°C (32°F to 95°F)
- Humidity: 10% to 95% @40°C (104°F) (no condensation on the device)
- Atmospheric Pressure: 70 kPa to 106 kPa (525 mmHg to 795 mmHg)
Transportation and Storage
For transportation and storage the recommended range for temperature and the humidity value for the device is as follows:
- Temperature: -20°C to 45°C (-4°F to 113°F)
- Humidity: 10% to 95% @40°C (104°F)(no condensation on the device)
- Atmospheric Pressure: 70 kPa to 106 kPa (375 mmHg to 795 mmHg)
The TD Pilot is not waterproof or fully water resistant. The device should not be kept in excessively humid, damp or otherwise wet conditions. Do not submerge the device in water or in any other liquid. Be careful not to allow liquids to be spilled upon the device especially in the connector areas without the I/O covers in place.
The device is registered as IP Class IP54.
The IP class pass for device only, with I/O covers in place. Adaptor mode is excluded.
Cleaning of the Device
- Before cleaning, fully shut down your device.
- Unplug your device.
- Remove all cables.
- Wipe over all external surfaces using 70 percent isopropyl alcohol wipe, 75 percent ethyl alcohol wipe, or Clorox Disinfecting Wipe for infection control.
- Allow the device to dry naturally.
- Any accessories included must also be disinfected in the same way.
- If streaky residue remains from cleaning, buff screen with a soft dry cloth.
- Dispose of used cleaning materials properly.
Do not use spray products directly on to the device as these may saturate the device and allow unwanted moisture into the unit.
Do not submerge the device in any liquid.
Do not use any bug spray on the device.
Placement
Only use the recommended mounts specified by your local reseller or sales representative and make sure that they are mounted and fastened correctly according to the instructions. Do not place the device on unstable and uneven surfaces.
Transporting the TD Pilot Device
Disconnect all the cables from the TD Pilot while carrying the device.
When you transport the device for repair, shipment, or traveling, use the original casing and packaging materials and ensure that the TD Pilot device is powered down.
It is recommended to keep the original packaging materials for the TD Pilot.
If the device needs to be returned to Tobii Dynavox for warranty-related issues or repair, it is beneficial that the original packaging or equivalent is used for shipping. Most shipping carriers require at least 2 inches of packing material around the device.
Note: Due to Joint Commission regulations, any shipping materials (including boxes) sent to Tobii Dynavox must be discarded.
Disposing of Batteries
Do not dispose of the batteries in general household or office waste. Follow your local regulations for the disposal of batteries.
Disposing of the Device
Do not dispose of the TD Pilot device in general household or office waste. Follow your local regulations for the disposal of electrical and electronic equipment.